Tool Management - Siemens SINUMERIK 840D sl Commissioning Manual

Tool management

12.1 Machine data for tool management
12.1.1 Settings with/without magazine management
Setting without magazine management
Make the following settings if you are commissioning the tool management without NC
magazine management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK
= 02H
Bit 1
MD20310 $MC_TOOL_MANAGEMENT_MASK
= 02H
Bit 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER
= 1FH
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
MD28450 $MC_MM_TOOL_DATA_CHG_BUFF_SIZE
= 100
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Provide monitoring data.
Monitoring functions of tool management active.
Tool status change.
Tool remaining unit quantity change.
Tool data change service.
Magazine data in the change service.
ISO data in the change service.
Number of entries in the buffer for the OPI change service for tool data. Dynamic memory
is used. This buffer is only created if either bit 2 or bit 3 is set in
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER.
Memory for the tool management is
reserved step-by-step (SRAM).
Activating the tool management
functions.
Marking the changed tool data for HMI.
Buffer for changing tool data (DRAM).
12
125