Configure The List Parameters - Siemens SINUMERIK 840D sl Commissioning Manual

12.2.3

Configure the list parameters

<PARAMETERCONFIGURATION> tag
In the <PARAMETERCONFIGURATION> tag, you have the following options:
1. Changing list parameters.
2. Creating new list parameters based on an existing parameter.
Changing list parameters
You can change all the parameters included in the system apart from the ISO parameters.
Tool parameter identifiers (Page 143)
Cutting parameter identifiers (Page 145)
Monitoring parameter identifiers (Page 148)
Grinding parameter identifiers (Page 148)
Magazine location parameter identifiers (Page 149)
Magazine location adapter parameter identifiers (Page 150)
Multitool parameter identifiers (Page 150)
Multitool location parameter identifiers (Page 152)
Entries
HeadLine
Tooltip
ShortText
DetailsText
Width
DisplayMode
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Meaning
Column header. Text entered is displayed as a header.
Example: Text "Radius" is displayed as a header (default).
Text that is displayed in the tooltip.
Example: Text "Geometry radius" is displayed in the tooltip (default).
Text if the parameter is displayed in the "More Data" window.
Example: Text "Rad." is displayed in the "More Data" window (default).
Text, if the parameter is displayed in the "Details" window.
Example: Text "Radius" is displayed in the "Details" window (default).
Column width in pixels in relation to a 640 x 480 resolution.
See example below: The default column width is changed to 53 pixels.
Values that the parameter is displayed with.
See example below: The default setting is changed to "DoubleMode".
The following values can also be accepted:
AnyMode
IntegerMode
UnsignedIntegerMode
DoubleMode
12.2 Configuring the user interface
All characters
Integers
Unsigned integers
Values with decimal places
The number of decimal places is specified in
"DecimalPlaces"
Tool management
153