Siemens SINUMERIK 840D sl Commissioning Manual page 495

MD20118 $MC_GEOAX_CHANGE_RESET
= 1
MD20140 $MC_TRAFO_RESET_VALUE
= 5
MD20144 $MC_TRAFO_MODE_MASK
Bit 0 = 1
MD20070 $MC_AXCONF_MACHAX_USED[4]
= 5
MD20080 $MC_AXCONF_CHANAX_NAME_TAB[ ]
[0] = XC
[1] = ZC
[2] = C
[3] = WZ
[4] = YC
Data set for inclined axis:
MD24430 $MC_TRAFO_TYPE_5
= 1024
MD24432 $MC_TRAFO_AXES_IN_5[ ]
[0] = 5
[1] = 1
[2] = 2
MD24434 $MC_TRAFO_GEOAX_ASSIGN_TAB_5[ ]
[0] = 1
[1] = 5
[2] = 2
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Allow automatic geometry axis change.
TRAANG always active after reset.
TRAANG runs in the background (persistent) and is not shown on the user interface.
Channel axis YC = 5th machine axis.
1. channel axis XC
2. channel axis ZC
3. channel axis C
4. channel axis WZ
5. channel axis YC
Transformation 5: TRAANG
1. transformation axis = channel axis, YC
2. transformation axis = channel axis, XC
3. transformation axis = channel axis, ZC
1. axis = channel axis, XC
2. axis = channel axis, YC
3. axis = channel axis, ZC
Configuring cycles
Name of channel axis in the channel.
Axis assignment for transformation 5.
Assignment of geometry axes to channel
axes for transformation 5.
22.5 Turning
489