Displaying Protection Area Elements For Collision Avoidance - Siemens SINUMERIK 840D sl Commissioning Manual

Collision avoidance
14.6 Changing and adapting the machine model view
14.6.5

Displaying protection area elements for collision avoidance

In the graphic display, you can select between the following display types:
● Display model
In the graphic display of the machine model, all elements are displayed where the
"Display" or "Display+monitoring" setting was selected for element value "Use".
● Monitoring model
In the graphic display of the machine model, all elements are displayed where the
"Monitoring" or "Display+monitoring" setting was selected for element value "Use".
Both display versions can be simultaneously selected.
Precondition
● You are in the graphic machine model editor.
● The "Graphic" and "Autozoom" softkeys are active.
Procedure
Setting the detail level
Note
One of the two display versions is always active!
244
1. Position the cursor in the graphic
2. Press the ">>" softkey.
The machine model with all display and monitoring elements is
displayed in the graphics window.
3. By deselecting, i.e. by pressing the corresponding softkey again, you
can display and hide the display elements and monitoring elements.
If, for protection elements, different detail levels are specified, then
softkeys are available that you can use to change the detail level.
1. Press the "Detail level +" softkey to display the next higher detail level.
- OR -
Press the "Detail level -" softkey to display the next lower detail level.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)