Manufacturer Cycles - Siemens SINUMERIK 840D sl Commissioning Manual

22.3

Manufacturer cycles

22.3.1 Manufacturer cycles
The following cycles are also available in the cycle package for individual adaptation:
CUST_TECHCYC.SPF
CUST_800.SPF
CUST_832.SPF
CUST_MEACYC.SPF
PROG_EVENT.SPF
CUST_T
CUST_M6
CUST_MULTICHAN
CUST_CLAMP
Copying manufacturer cycles
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Manufacturer cycle for the adaptation of technology cycles.
Manufacturer cycle for the adaptation of the swivel plane and the swivel
tool functions (CYCLE800), see Chapter "Manufacturer cycle
CUST_800.SPF (Page 518)".
Manufacturer cycle for the adaptation of the high speed settings
function (CYCLE832)", see Chapter Manufacturer cycle
CUST_832.SPF (Page 529)".
Manufacturer cycle for the adaptation of the measuring functions, see
Chapter "Manufacturer and user cycle CUST_MEACYC.SPF
(Page 535)".
Standard cycle to support the following functions:
Block search when milling or turning is activated
•
Block search and swivel plane
•
Block search and align / advance tool
•
Observe MD52212 $MCS_FUNCTION_MASK_TECH bit 3 and bit 5.
Cycle is used to track the T preparation after SERUPRO.
Cycle is used to track the tool change after SERUPRO.
Manufacturer cycle for lathes with several channels
Manufacturer's cycle for clamping elements
1. Select the "Start-up" operating area.
2. Press the "System data" softkey.
3. Open the directory NC data/Cycles/Standard cycles and select the
manufacturer cycles.
Configuring cycles
22.3 Manufacturer cycles
457