Siemens SINUMERIK 840D sl Commissioning Manual page 658

Dialogs
4.2 Defining softkey menus
Storage locations
The image matching the resolution of the connected monitor is searched for in the
associated resolution directories in the following sequence:
/user/sinumerik/hmi/ico/ico<Resolution>
/oem/sinumerik/hmi/ico/ico<Resolution>
/addon/sinumerik/hmi/ico/ico<Resolution>
If the image is not displayed or not found, copy it into one of the following directories for a
resolution of 640 x 480 pixels:
/user/sinumerik/hmi/ico/ico640
/oem/sinumerik/hmi/ico/ico640
/addon/sinumerik/hmi/ico/ico640
Note
With the different panel resolutions, the images are positioned proportionally.
4.2 Defining softkey menus
Definition
The term softkey menu is used to refer to all the horizontal and vertical softkeys displayed on
a screen form. In addition to the existing softkey menus, it is possible to define other menus,
which partially or completely overwrite the existing menus.
The names of the softkeys are predefined. Not all softkeys need to be assigned.
HSx x 1 - 8, Horizontal softkeys 1 to 8
VSy y 1 - 8, Vertical softkeys 1 to 8
The definition of a softkey menu (softkey menu definition block) is basically structured as
follows:
Definition block
//S...
HSx=...
PRESS(HSx)
LM...
END_PRESS
//END
40
Comment
;Start identifier of softkey menu
;Define softkeys
;Method start identifier
;Actions
;Method end identifier
;End identifier of softkey menu
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1
Chapter reference
See chapter "Methods"
SINUMERIK Integrate Run MyScreens (BE2)