Configuration Upload Page (Gdu Software Version 7.01 Or Later) - Garmin G1000 NAV III Line Maintenance Manual

GDU software version 7.01 or later
i. Using the FMS knob navigate to the SYSTEM UPLOAD page as shown in Figure 2-29.
ii. Using the FMS knob select the Configuration Files in the AIRFRAME field.
iii. Using the FMS knob select the Cessna SEP – Offset Error Correction File in the FILE field.
iv. Verify the configuration box is checked.
v. Press the LOAD softkey.
Figure 2-29. CONFIGURATION UPLOAD Page (GDU software version 7.01 or later)
29. Power down PFD1 and MFD1.
A. AVIONICS Switch (BUS 1 and BUS 2) – Off
B. MASTER Switch (BAT) – Off
30. Remove the SD card from the PFD.
31. Power up MFD1 and PFD1 in Normal mode:
A. STBY BATT Switch – Arm
B. Ensure STBY BATT CB is open
C. MASTER Switch (BAT) – On
D. AVIONICS Switch (BUS 1 and BUS 2) – On
32. Record the BATT S current (in Amps) from the bottom right corner of the EIS strip. Label this reading as
READING #2 and ensure proper sign (+ or -).
In the Aircraft:
33. Power down PFD1 and MFD1.
A. AVIONICS Switch (BUS 1 and BUS 2) – Off
B. MASTER Switch (BAT) – Off
C. STBY BATT Switch – Off
G1000 Nav III Line Maintenance Manual
190-00352-00
Page 2-69
Rev. L