Upload Complete Window - Garmin G1000 NAV III Line Maintenance Manual

15. Press the ENT key to confirm upload completion (Figure 6-2).
16. Remove the SD card from the PFD.
17. Remove power to all GDUs.
18. Power on the MFD and PFD in normal mode, and leave on for at least 11 minutes.
19. Remove power from the MFD and PFD.
20. Turn on the MFD and PFD in configuration mode by holding down the ENT key while applying
power (release the ENT key when the words "INITIALIZING SYSTEM" appear on the display).
21. Use the FMS knob to select the GDU TEST Page. Verify that the "BKUP CAPS" checkbox on
the GDU TEST Page is green (Figure 6-3), for each GDU. If the "BKUP CAPS" checkbox is red
return the GDU to Garmin for repair.
22. Backload the MFD and PFD to currently approved system software version and reconfigure per
Section 4.1 "Displays with Power Interrupt Software Installed" of this manual.
Loading test software 006-B0380-15 to the GDUs changes the GDU software
version to v7.10. It is required to return the GDU to the currently approved
system software version and configuration.
G1000 Nav III Line Maintenance Manual
190-00352-00
Figure 6-2. Upload Complete Window
Figure 6-3. BKUP CAPS Checkbox on GDU TEST Page
NOTE
Page 6-5
Rev. L