Garmin G1000 NAV III Line Maintenance Manual page 138

4.3.2 GIA GPS Software (GDU software version 6.01 and earlier)
1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.
2. Apply system power, insuring both MFD and PFD are in Configuration Mode.
3. Press the CLR key at the "Do you want to update system files?" prompt.
4. Rotate the small FMS knob to the SOFTWARE UPLOAD page.
5. Turn on the cursor by pressing the FMS knob.
6. Rotate the small FMS knob to select GPS software.
7. Press the LOAD softkey.
8. Press the ENT key at the "BEGIN FILE UPLOAD?" prompt.
9. Confirm update completion and press the ENT key.
10. Confirm correct software part number and software version on the SYSTEM STATUS page.
For software/configuration troubleshooting see Section B.4, otherwise continue to Section 4.3.3.
4.3.3 GIA Audio Software (GDU software version 6.01 and earlier)
1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.
2. Apply system power, insuring both MFD and PFD are in Configuration Mode.
3. Press the CLR key at the "Do you want to update system files?" prompt.
4. Rotate the small FMS knob to the SOFTWARE UPLOAD page.
5. Turn on the cursor by pressing the FMS knob.
6. Rotate the small FMS knob to select GIA AUDIO software.
7. Press the LOAD softkey.
8. Press the ENT key at the "BEGIN FILE UPLOAD?" prompt.
9. Confirm update completion and press the ENT key.
10. Confirm correct software part number and software version on the SYSTEM STATUS page.
11. If the AUDIO software load failed, load GIA Boot Block software per 4.3.1.2.
For software/configuration troubleshooting see Section B.4, otherwise continue to Section 4.3.4.
4.3.4 GIA Configuration (GDU software version 6.01 and earlier)
1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.
2. Start the G1000 system in Configuration mode, if the system is not already in Configuration mode.
3. Press the CLR key at "DO YOU WANT TO UPDATE SYSTEM FILES?" prompt.
4. Using the FMS knob go to the Configuration Upload page on the PFD.
5. Activate the cursor and highlight the appropriate file in the FILE field.
6. Press the ENT key.
7. Highlight 'GIA 1' in the SECTION field.
8. Press the LOAD softkey.
9. Select YES and press the ENT key to acknowledge the prompt.
10. Monitor the status of the upload. When the upload is finished, press the ENT key to acknowledge the
confirmation.
11. Highlight 'GIA 2' in the SECTION field and repeat Steps 7 through 9.
12. Highlight 'AUDIO' in the SECTION field and repeat Steps 7 through 9.
13. View the SUMMARY field and ensure that the load is 'complete', then de-activate the cursor.
14. Verify the correct part number and software version on the SYSTEM STATUS page.
Reference Section B.1.6 for configuring optional equipment. For software/configuration troubleshooting see
Section B.4. For Stormscope configuration see Section 4.3.6, otherwise continue to Section 4.3.7.
Page 4-12
Rev. L
G1000 Nav III Line Maintenance Manual
190-00352-00