2.1.1.1 System Annunciation Troubleshooting
Annunciation
NAV1 or COM1
NAV2 or COM2
GPS INTEG or Time
XPDR FAIL
TAS, AIRSPEED FAIL,
ALTITUDE FAIL,
VERT SPEED FAIL
OAT
and
TAS
Page 2-2
Rev. L
Associated
Solution
LRU
•
Check configuration settings for GIA1 and the PFD
•
Check Ethernet interconnect from GIA1 to the PFD
•
GIA1
Switch GIA1 and GIA2, to verify location of problem:
If problem follows GIA1, replace GIA1.
o
If problem persists, replace PFD.
o
•
Check configuration settings for GIA2 and the MFD
•
Check Ethernet interconnect from GIA2 to the MFD
•
GIA2
Switch GIA1 and GIA2, to verify location of problem:
If problem follows GIA2, replace the GIA2.
o
If problem persists, replace MFD.
o
•
Ensure that a cell phone or a device using cell phone
technology is not turned on (even in a monitoring state) in
the cabin.
•
Check GPS1 and GPS2 signal strength on AUX page 3
•
Check corresponding GPS antenna and cable
GIA1 or 2
•
Check Ethernet interconnect between the PFD and GIA1
or MFD and GIA2 for faults.
•
Switch GIA1 and GIA2, to verify location of problem:
If problem follows the GIA, replace the GIA.
o
If problem persists, replace the MFD or PFD.
o
•
Check GTX 33 configuration settings for GIA1 and GIA2
•
Perform a SET>ACTV configuration reset on the GTX
GTX 33
Config page, and verify the aircraft registration is present.
•
Replace the GTX 33
•
Inspect GDC 74A pitot/static plumbing integrity.
•
Inspect pitot/static ports and associated equipment.
•
For TAS failure, also check GTP 59 probe.
•
Check GDC 74A configuration settings for the PFD, MFD,
GDC 74A
GIA1, and GIA2
If PFD, MFD, and GIA configuration settings are
o
correct, replace the GDC configuration module.
If problem persists, replace the GDC 74A
o
•
Check OAT probe wiring and connectors for faults.
•
Check GDC config module wiring for damage, replace if
any is found.
GTP 59
•
Replace GDC config module
•
Replace GDC 74A with a known good unit:
If problem persists, replace the GTP 59.
o
G1000 Nav III Line Maintenance Manual
190-00352-00