Waas (Gia 63W) System Status Page - Garmin G1000 NAV III Line Maintenance Manual

Select the correct FILE to load (WAAS or Non-WAAS) as determined by the GIA installed in the
aircraft. Loading the incorrect software may make the GIA 63 or GIA 63W inoperable and
necessitate returning the unit to Garmin for non-warranty repair. No warning appears if the
wrong software is selected.
4.3.1 GIA Main Software (GDU software version 6.01 and earlier)
If a new GIA 63 (Non-WAAS) has been installed (new serial number), the following procedure
applies. Otherwise continue to 4.3.1.3. Non-WAAS GIA v4.01 (or later) boot block software
must be installed prior to upgrading to software versions listed in this document. Boot Block
software is available from the Cessna provided G1000 software CD-ROM.
4.3.1.1 Determining Current Boot Block
1. Ensure the G1000 is powered off.
2. Insert the airframe specific approved software loader card (containing GIA main software version 4.00 or
later) into the top slot of the PFD.
3. While holding the ENT key on the PFD, restore power to the PFD.
G1000 Nav III Line Maintenance Manual
190-00352-00
Figure 4-3. WAAS (GIA 63W) System Status Page
Figure 4-4. System Upload Page
NOTE
Page 4-9
Rev. L