Garmin G1000 NAV III Line Maintenance Manual page 239

B.2.2 Stormscope Configuration (If Equipped)
1. Select the GIA page group on the PFD. The GIA RS-232/ARINC 429 Configuration Page appears by
default.
2. Select the appropriate GIA 63 to be configured. Refer to aircraft-specific installation drawings to find out
which GIA is used to communicate with the Stormscope (In some cases, both GIAs may be used as
communication paths).
3. Activate the cursor and toggle to the appropriate GIA RS-232 input channel.
4. Use the FMS Knob to select 'WX-500' from the menu.
5. Acknowledge the selection by pressing the ENT key. Repeat Steps 2-5 for the opposite GIA, if required.
6. Configuration for the G1000-Stormscope interface is complete. Note that a new page group, labeled
'OTHER' appears. A Stormscope configuration page is now available in this page group to further
configure the Stormscope. Refer to the WX-500 installation manual for information on Stormscope post-
installation procedures.
G1000 Nav III Line Maintenance Manual
190-00352-00
Page B-25
Rev. L