Garmin G1000 NAV III Line Maintenance Manual page 129

GDU software version 7.01 and later
No configuration is required. Configuration and lighting settings are automatically updated. However, the
configuration procedure is provided for instances where re-loading the configuration files may be appropriate.
1. Insert the Nav III airframe specific G1000 Software Loader Card into top slot of the PFD.
2. Start the G1000 system in Configuration mode, if the system is not already in Configuration mode.
3. Press the CLR key at "DO YOU WANT TO UPDATE SYSTEM FILES?" prompt.
4. Using the FMS knob go to the System Upload page on the PFD.
5. Activate the cursor and highlight the appropriate airframe in the AIRFRAME field.
6. Press the ENT key.
7. Highlight the appropriate full configuration in the FILE field.
Loading the wrong software into GIA63/63W units may cause an inoperable condition that
is not covered by warranty. Refer to Section 4.3 of this manual to identify which type of GIA
63 (WAAS or Non-WAAS) is installed in the aircraft, and how to choose the correct WAAS or
Non-WAAS software file. Loading the incorrect software may make the GIA 63 or GIA 63W
inoperable and necessitate returning the unit to Garmin for non-warranty repair. No warning
appears if the wrong software is selected.
8. Press the ENT key.
9. Press the CLR ALL softkey.
10. Using the FMS knob select the following files:
•
Airframe
•
System
•
Manifest
•
MFD
•
PFD
Pressing the ENT key will check and uncheck the highlighted software and configuration boxes.
11. Once the desired files are selected press the LOAD softkey.
12. Verify the correct part number and software version on the SYSTEM STATUS page.
G1000 Nav III Line Maintenance Manual
190-00352-00
CAUTION
NOTE
Page 4-3
Rev. L