Garmin G1000 NAV III Line Maintenance Manual page 158

Loading the wrong software into GIA63/63W units may cause an inoperable condition that
is not covered by warranty. Refer to Section 4.3 of this manual to identify which type of GIA
63 (WAAS or Non-WAAS) is installed in the aircraft, and how to choose the correct WAAS or
Non-WAAS software file. Loading the incorrect software may make the GIA 63 or GIA 63W
inoperable and necessitate returning the unit to Garmin for non-warranty repair. No warning
appears if the wrong software is selected.
8. Press the ENT key.
9. Press the CLR ALL softkey.
10. Using the FMS knob select the following files:
If a new GDC was installed
•
GDC Software
•
GDC Configuration
If a new GDC configuration module was installed
•
GDC Configuration
Pressing the ENT key will check and uncheck the highlighted software and configuration boxes.
11. Once the desired files are selected press the LOAD softkey.
12. Verify the correct software part number and software version on the SYSTEM STATUS page.
For software/configuration troubleshooting see Section B.4, otherwise continue to Section 4.5.4.
Page 4-32
Rev. L
CAUTION
NOTE
G1000 Nav III Line Maintenance Manual
190-00352-00