Fuel Level Adjustment - Yamaha TW200 Service Manual

____________
~_R_B_U_R_U_O_R_I~RBI.I
2. Adjust:
-Throttle cable free play
Refer to the I'THROTILE CABLE FREE
PLAY ADJUSTMENT" section in the
"CHAPTER 3".
Throttle Cable Free Play:
2-5 mm (0.08-0.20 in)
®
FUEL LEVEL ADJUSTMENT
NOTE: _
Before adjusting the fuel level, the float height
should be adjusted.
1. Place
~he
motorcycle on a level place.
2. Use a garage jack under the engine to ensure
that the carburetor is positioned vertically.
3. Attach the Fuel Level Gauge
CD
to the float
chamber nozzle.
lEI
Fuel Level Gauge:
Q'-
PIN YM-01312
4. Loosen the drain screw
®,
and warm up the
engine for several minutes.
5. Measure:
- Fuel level
®
Out of specification--+- Adjust.
Fuel Level
@:
7.5-8.5 mm (0.30-0.33 in)
Below the Carburetor Body Edge
5-9
6. Adjust:
-Fuel level
Adjustment steps:
- Remove the carburetor.
-Inspect the valve seat and needle valve.
-If either is worn, replace them both.
-If both are fine, adjust the float height by
bending the float tang
CD
on the float.
- Recheck the fuel level.
t