Yamaha TW200 Service Manual page 144

Cam sprocket installation steps:
-Install the dowel pins (Crankcase cover-Left)
and crank case cover (Left).
-Turn the crankshaft
counterclockwi~e
to align
the liT" mark
CD
on the rotor with the crank-
case cover mark
~
when the piston is at
TDC on the compression stroke.
-Install the cam sprocket.
NOTE: _
Align the sprocket timing mark
~
with the
cylinder head timing mark
CD.
ENGINE ASSEMBLY AND ADJUSTMENT I
ENG
I" ..
I
4. Install:
- Cam sprocket
- Remove the crankcase cover (Left) and dowel
. pins.
-Tighten the bolt (Cam sprocket) while hold-
ing the crankshaft.
Bolt (Cam Sprocket):
60 Nm (6.0 m.kg, 43 ft.lb)
CD-@oo~
,
5. Install:
-Springs
CD
- Tensioner rod ~
-Spring retainer
®
-Cam chain adjuster
@
-Locknut
@
6. Turn in the cam chain adjuster
CD
until speci-
fied tensioner rod position
®
is obtained.
Tentioner Rod Position:
0-0.5
mm
(0-0.02
in)
4-64