Installation - Yamaha TW200 Service Manual

DRIVE CHAIN AND SPROCKETS
ICHASI
~
I
4. Inspect:
Drive sprocket/ Driven sprocket
More than 1/4 teeth
CD
wear~
Replace
sprocket.
Bent
teeth~
Replace sprocket.
(2)
Correct
®
Roller
@
Slip off
WARNING:
Always use new lock washers.
Driven sproc'ket replacement steps:
- Straighten the lock washer tabs and remove
the driven sprocket
CD.
-Install a new driven sprocket and lock
washers.
Nut (Driven Sprocket):
35 Nm (3.5 m-kg, 25 ft-Ib)
Use
LOCTITE@.
- Bend the lock washer tabs along the nut flats.
INSTALLATION
Reverse the removal steps.
Note the following points.
1. Install:
-Rear wheel
Refer to "CHAPTER 3-REAR WHEEL IN-
STALLATION" section.
, Nut (Rear Wheel):
~
90 Nm (9.0 m.kg, 65 ft·lb)
2. Install:
- Drive sprocket
- Fitting plate
, Bolt (Drive Sprocket):
4 Nm (0.4 m-kg, 2.9 ft-Ib)
6-34