All Replacement Parts; Gaskets, Oil Seals, And O-Rings; Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals - Yamaha TW200 Service Manual

IMPORTANT INFORMATION
I
~~~
I
~I
ALL REPLACEMENT PARTS
1. Use only genuine Yamaha parts for all replace-
ments. Use oil and/ or grease recommended
by Yamaha for assembly and adjustment.
Other brands may be similar in function and
appearance, but inferior in quality.
D
GASKETS, OIL SEALS, AND O-RINGS
1. All gaskets, seals, and a-rings should be
replaced when an engine is overhauled. All
gasket surfaces, oil seal lips and a-rings must
be cleaned.
2. Properly oil all mating parts and bearings dur-
ing reassembly. Apply grease to the oil seal
lips.
300-000
300-003
300-002
LOCK WASHERS/PLATES AND COTTER
PINS
1. All lock washers/ Plates
CD
and cotter pins
must be replaced when they are removed.
Lock tab(s) should be bent along the bolt or
nut flat(s) after the bolt or nut has been
properly tightened.
BEARINGS AND OIL SEALS
1. Install the bearing(s) and oil seal(s) with their
manufacturer's marks or numbers facing out-
ward. (In other words, the stamped letters
must be on the side exposed to view.)
When installing oil seal(s), apply a light coat-
ing of light-weight lithium base grease to the
seal lip(s). Oil the bearings liberally when in-
stalling.
CD
Oil seal
111'1·~811
_
Do not use compressed air to spin the bear-
ings dry. This causes damage to the bearing
surfaces.
CD
Bearing
1-3