Installation - Yamaha TW200 Service Manual

®
6-5
FRONT WHEEL
ICHASI
r/::Y
0
1
10. Inspect:
• Brake drum inner surface
Rust/Oil/Scratches
~
Remove.
Oil
Use a rag soaked in lacquer
thinner or solvent.
Scratches
Use an emery cloth
(lightly and evenly
polishi~g).
11. Measure:
-Brake drum inside diameter
®
Out of
specification~Replace.
Brake Drum Wear Limit:
131
mm
(5.16
in)
INSTALLATION
Reverse the removal procedure.
Note the following points.
1. Apply:
• Lithium soap base grease
To the oil seal lips and axle shaft.
• Wheel bearing grease
To the wheel bearing.
2. Install:
• Brake shoe plate
NOTE: _
Check for proper engagement of the boss on the
outer fork tube with the locating slot on the brake
shoe plate.
3. Tighten:
.Nut (Front wheel axle)
~
Axle Nut:
~
Nm (9.0 m-kg, 65 ft-Ib)
4. Adjust:
• Front brake
Refer to the IIFRONT BRAKE ADJUST-
MENT" section in the IICHAPTER 3".