Omron SYSMAC CS Series Operation Manual page 87

CS1/CJ1W-PRM21 PROFIBUS Master DTM
Master DTM Configuration
User Interface
Configuration Interface
Buttons
!Caution Save in the context of the buttons means that the changes made by the user
66
Note The Configuration User Interface for each of the two CS1/CJ1 PROFIBUS
Master DTMs contains the same views and setting options.
The Master DTM Configuration User Interface contains four tabs:
• Device Setup tab
• Master Setup tab
• Bus Parameters tab
• Slave Area tab
The four tabs are discussed below.
The Master DTM Configuration User Interface contains four general buttons.
They are listed in the table below, together with the action taken when press-
ing them.
Button
OK Evaluate, and save the changes made (if any) and close the user
interface.
Note If any invalid settings have been made, a warning message
Cancel Closes the user interface without saving.
Note If any changes were made, a warning message is displayed,
Help Launch context sensitive Help for the Active tab.
Save Evaluate changes and save them.
are saved in the DTM only, i.e. the changes are not permanently saved in the
Project yet. This is indicated by the asterisk next to the DTM in the Network
view. The next time in the same session the GUI is opened, the changes will
still be there. In order to save the changes permanently, e.g. to hard disk,
Click the File - Save option from the main menu of CX-Profibus.
Action
will be displayed, allowing cancellation of the command.
allowing cancellation of the command.
Section 3-3