Omron SYSMAC CS Series Operation Manual page 42

CX-Profibus Configurator
Downloading the
Configuration
CS/CJ-series
PROFIBUS DP
Master Unit
Note The Generic Slave DTM provides parameter settings related to PROFIBUS
DP-V1. However, it does not support PROFIBUS DP-V1 communication.
After setting up the configuration, it must be downloaded to the PROFIBUS
Master Unit. The type of serial connection to use for downloading, depends
on the Unit:
• CS1/CJ1W-PRM21: Connection to the Unit is achieved through the serial
port of the PLC CPU, using CX-Server. CX-Server also allows routing the
download through multiple systems, if supported by these systems. The
CS1/CJ1W-PRM21 does not support message routing.
• C200HW-PRM21: Connection to the C200HW-PRM21 is achieved
through a serial RS-232c Connection between one of the PC's Serial
COM Ports and the dedicated configuration connector at the front of the
Unit. For details, refer to the C200HW-PRM21 Manual: W349-E2-2. The
figure below shows the connection methods, for both types.
Serial connection to CS/CJ-series
PROFIBUS DP Master Unit
COM Port on PC
Peripheral Bus or
Host LINK
OMRON
SYSMAC CS1G
PROGRAMMABLE
CONTROLLER
Peripheral or RS232C
Port of CPU Unit
PROFIBUS Network
Serial connection to C200H-series
PROFIBUS DP Master Unit
CX-Profibus
Configurator
COM Port on PC
C200H-series
PROFIBUS DP
Master Unit
PROFIBUS Network
Section 1-4
CX-Profibus
Configurator
OMRON
SYSMAC CS1G
PROGRAMMABLE
CONTROLLER
Configuration Port on
PROFIBUS DP
Master Unit
21