Omron SYSMAC CS Series Operation Manual page 162

Command / Response Reference
Get_Cfg Service
Command Format
Response Format
Parameters
Response Codes
The PROFIBUS DP Get_Cfg service allows a PROFIBUS Master Unit to read
the I/O Configuration data of any slave device, even if it is not allocated to the
Master Unit.
The figures below show the command and response message formats.
28 09 3B
Command
code
Device
address
Device Service
Access Point
28 09
Command Response Device
code code address
Destination Address (Command, Response)
The address of the device on the PROFIBUS network, to which the PROFI-
BUS message will be sent. The valid address range is 0 to 7E (Hex). The
most significant byte in the Response Format is set to 00.
Device Service Access Point (Command)
The Device Service Access Point for the Get_Cfg PROFIBUS service must be
set to 3B (Hex).
Data length (Bytes) (Response)
This parameter defines the number of I/O Configuration bytes returned by the
slave device. The number ranges from 0 to 244 bytes. The most significant
byte is set to 00.
I/O Configuration data (Response)
I/O Configuration data returned by the slave device. The I/O Configuration
bytes are coded according to the PROFIBUS standard.
Response code
0000 Normal completion
1001 Command too large, i.e. > 2 words
1002 Command too short, i.e. < 2 words.
110C Device Address Invalid, i.e. > 7E (Hex)
2208 PROFIBUS Master unit not in correct mode, i.e. it is in
OFFLINE mode.
0001 • The slave has deactivated this service.
• The slave has not responded to the request.
• The slave does not have sufficient memory space for the re-
quest data.
• Destination address is same as current master address.
0402 Service is not supported: Device Service Access Point is
invalid.
Data length I/O Configuration
(bytes) data
Description
Section 5-2
141