Configuring Cx-Server - Omron SYSMAC CS Series Operation Manual

Configuring the Master
6-4-4

Configuring CX-Server

Configuring
Communication
1,2,3...
CX-Server
Configuring CX-Server
1,2,3...
The CS1/CJ1W-PRM21 Master DTM uses CX-Server to connect to the Unit
for downloading a configuration as well as monitoring the Master Unit. To
setup the communication to the Unit, perform the following procedure.
1. Open the CS1/CJ1W-PRM21 Master DTM Configuration Interface, Device
Setup tab.
2. Make sure that the Unit Number has been set to the unit number set on the
PROFIBUS Master Unit, through the rotary switch on the front.
3. Select the Configure button to start CX-Server.
Up on pressing the Configure button, CX-Server is launched and displays the
CX-Server User Interface as shown below.
In order to configure CX-Server for communication with the Unit, perform the
following procedure.
1. Select the type of PLC to which the Unit is attached, from the Device Type
drop down selection box.
2. Press the Settings button next to the PLC type selected. The PLC settings
window (see figure below) is displayed.
3. In this window make the proper adjustments if necessary. The selections
made, must match the physical configuration of the PLC system. When
done, press the OK button.
Section 6-4
165