Omron SYSMAC CS Series Operation Manual page 217

Monitoring the Network
Reading the Error Log
1,2,3...
Clearing the Error Log
1,2,3...
196
The Error Log can now be retrieved from the Unit, and displayed through the
CS1/CJ1W-PRM21 Master DTM Diagnosis User Interface. To retrieve and
view the Unit's Error Log,
1. Open the CS1/CJ1W-PRM21 Master DTM Diagnosis User Interface.
2. Select the Monitor - Error History Tab tab.
3. If the Automatic checkbox in the Refresh box has not been selected, press
the Manual button to retrieve the Error Log contents from the Unit.
As an example, the contents of the Error Log as it is displayed is shown in the
figure below. In this case a Hardware Error has been detected on the PROFI-
BUS network.
Note Reading the Error Log contents will not clear it.
In order to clear the Error Log, perform the following actions.
1. Open the CS1/CJ1W-PRM21 Master DTM Diagnosis User Interface.
2. Select the Monitor - Error History Tab tab.
3. Press the Clear button in the lower right corner of the window.
Section 6-7