Omron SYSMAC CS Series Operation Manual page 175

Setting up a network
Changing the DTM
address via the Master
DTM
1,2,3...
154
3. Select the OK or Apply button at the bottom of the window. The OK button
will close the DTM Configuration User Interface.
Note If, when pressing the Apply or OK button, no I/O modules have been selected
as yet, a warning message will be displayed. The I/O modules can be
selected later. Pressing the OK button with the warning, will apply the
changed device address.
After changing the address in the slave DTM Configuration User Interface, the
updated address will be shown in the Network view, next to the device name.
The slave DTM address can also be changed via the Master DTM. To accom-
plish this, first open the Slave DTM Address Assignment table.
1. Select the Master DTM in the Network view.
2. Right click the mouse, and select the Additional functions entry from the
context menu.
3. Select the Slave DTM Address Assignment function.
Section 6-2