Chrysler Concorde 2004 Service Manual page 1526

5 - 60 BRAKES - BASE BRAKE SYSTEM
PARKING BRAKE LEVER (Continued)
(16) Reinstall the fuse panel cover on left side of
instrument panel.
(17) Reinstall driver's side kick panel
(18) Reinstall driver's door opening sill cover
(19) Raise the vehicle up.
(20) Reconnect the cable connector between the
front and intermediate cables.
(21) Adjust parking brake. (Refer to 5 - BRAKES -
BASE/PARKING BRAKE - ADJUSTMENTS)
(22) Lower the vehicle.
PARKING BRAKE SHOES
REMOVAL - PARKING BRAKE SHOES
(1) Remove rear disc brake caliper assembly from
adapter and rotor. (Refer to 5 - BRAKES - BASE/HY-
DRAULIC/MECHANICAL/DISC BRAKE CALIPERS
- REMOVAL)
(2) Remove rear rotor from rear hub.
(3) Remove dust cap from rear hub.
(4) Remove the cotter pin, nut retainer, wave
washer and rear hub/bearing assembly retaining nut
and washer from the rear spindle.
(5) Remove rear hub and bearing assembly from
rear spindle.
(6) Remove rear brake shoe assembly hold down clip.
(7) Turn brake shoe adjuster wheel until adjuster
is at shortest length.
(8) Remove adjuster assembly from the parking
brake shoe assemblies.
(9) Remove lower shoe to shoe spring.
(10) Pull rear brake shoe assembly away from
anchor, then remove rear brake shoe and upper spring.
(11) Remove front brake shoe hold-down clip, then
remove front brake shoe assembly.
INSTALLATION - PARKING BRAKE SHOES
(1) Install front brake shoe and hold down clip.
(2) Install rear brake shoe and the upper brake
shoe to shoe return spring.
(3) Pull rear brake shoe over anchor block until
properly located on adapter.
(4) Install the lower shoe to shoe return spring.
(5) Install brake shoe adjuster assembly with star
wheel rearward.
(6) Install rear brake shoe hold down clip.
(7) Adjust brake shoes to a diameter to 171 mm
(6.75 inch).
(8) Install rear hub and bearing assembly on spin-
dle.
(9) Install hub and bearing assembly washer and
retaining nut. Torque the hub and bearing assembly
retaining nut to 168 N·m (124 ft. lbs.).
(10) Install the wave washer, retaining nut and
cotter pin.
(11) Install hub and bearing assembly dust cap.
(12) Install rear brake rotor.
(13) Install rear disc brake caliper on the adapter.
(Refer to 5 - BRAKES - BASE/HYDRAULIC/ME-
CHANICAL/DISC BRAKE CALIPERS - INSTALLA-
TION)
(14) Install wheel and tire assemblies. Tighten
wheel mounting nuts to 135 N·m (100 ft.lbs.).
LH