Chrysler Concorde 2004 Service Manual page 1518

5 - 52 BRAKES - BASE BRAKE SYSTEM
ROTOR (Continued)
Braking Rotor Rotor Thickness
25.87–26.13 mm
Front Rotor
1.019 -1.029 in.
11.63–12.13 mm
Rear Rotor
.458 -.478 in.
* TIR Total Indicator Reading (Measured On Vehicle)
REMOVAL
REMOVAL - BRAKE ROTOR (FRONT)
(1) Remove disc brake caliper and store (hang) it
out of the way following the procedure found in
Brake Pads/Shoes. (Refer to 5 - BRAKES - BASE/HY-
DRAULIC/MECHANICAL/BRAKE PADS/SHOES -
REMOVAL)
(2) Remove any clips retaining the brake rotor to
the wheel mounting studs.
(3) Remove brake rotor from hub by pulling it
straight off wheel mounting studs (Fig. 93).
Fig. 93 Front Rotor Removal/Installation
1 - HUB
2 - STEERING KNUCKLE
3 - BRAKE ROTOR (DISC)
4 - WHEEL MOUNTING STUD
BRAKE ROTOR REFINISHING LIMITS
Minimum
Rotor
Thickness
24.4 mm
.960 in.
10.4 mm
.409 in.
Rotor Rotor Run
Thickness
Variation
.013 mm
.0005 in.
.013 mm
.0005 in.
REMOVAL - BRAKE ROTOR (REAR)
(1) Remove disc brake caliper and store (hang) it
out of the way following the procedure found in
Brake Pads/Shoes. (Refer to 5 - BRAKES - BASE/HY-
DRAULIC/MECHANICAL/BRAKE PADS/SHOES -
REMOVAL)
(2) Remove any clips retaining the brake rotor to
the wheel mounting studs.
(3) Remove the rear rotor from hub by pulling it
straight off the wheel mounting studs (Fig. 94).
Fig. 94 Rear Rotor Removal/Installation
1 - BRAKE ROTOR (DISC)
2 - DISC SHIELD
3 - HUB
4 - DRUM-IN-HAT PARKING BRAKE
Rotor Micro
Out* Finish
.08 mm
15-80 RMS
.003 in.
.08 mm
15-80 RMS
.003 in.
LH