Ignition Coil Assembly (Including Ignitor) Removal And Installation; Ignition Coil Assembly (Including Ignitor) Inspection; Ignition Timing Inspection - Suzuki 2006 SX4 Service Manual

Ignition Coil Assembly (Including Ignitor)
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove air cleaner assembly with air intake pipe
and cylinder head upper cover.
3) Disconnect ignition coil coupler.
4) Disconnect high-tension cord (3) from ignition coil
assembly (2).
5) Remove ignition coil bolts (1) and then pull out
ignition coil assembly.
Installation
1) Install ignition coil assembly (2).
2) Tighten ignition coil bolts (1) to specified torque, and
then connect ignition coil coupler.
Tightening torque
Ignition coil bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
3) Install high-tension cord (3) to ignition coil assembly
while gripping its cap.
4) Install cylinder head upper cover and air cleaner
assembly with air intake pipe.
5) Connect negative cable to battery.
Ignition Coil Assembly (Including Ignitor)
Inspection
S6RW0D1806005
Measure secondary coil for resistance.
If resistance is out of specification, replace ignition coil
assembly.
Secondary coil resistance
7.6 – 10.2 kΩ at 20 ° (68 °F)

Ignition Timing Inspection

NOTE
• Ignition timing is not adjustable. If ignition
timing is out of specification, check
I2RH0B180006-01
system related parts.
• Before starting engine, place transmission
gear shift lever in "Neutral", and set
parking brake.
1) Connect scan tool to DLC (1) with ignition switch
OFF.
Special tool
(A): SUZUKI scan tool (SUZUKI-SDT)
I3RM0A180004-01
Ignition System:
1
(A)
1H-8
S6RW0D1806006
I2RH0B180007-01
S6RW0D1806007
I5RW0C110011-01