EVAPORATOR
EVAPORATOR INSPECTION
1. Inspect the evaporator for damage, cracks and oil leakage.
If there is any malfunction, replace the evaporator.
•
2. Visually inspect the fins for bending.
If there is any bending, use the end of a flathead screwdriver to straighten the fins.
•
HEATER CORE
HEATER CORE INSPECTION
1. Inspect the heater core for damage, cracks and water leakage.
If there is any malfunction, replace the heater core.
•
2. Visually inspect the fins for bending.
If there is any bending, use the end of a flathead screwdriver to straighten the fins.
•
3. Visually inspect the heater hose for deformation.
Repair with pliers if there is deformation. If there is any malfunction, replace the heater core.
•
AIRFLOW MODE MAIN LINK
AIRFLOW MODE MAIN LINK REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the A/C amplifier.
3. Remove the airflow mode link set.
4. Remove the airflow mode main link as shown in the figure.
5. Install in the reverse order of removal.
(w)
RX-8 - HVAC
Page 9