DTC P0768
DTC P0768
Shift solenoid C circuit malfunction (open circuit/short to ground or power supply)
DETECTION
CONDITION
POSSIBLE
CAUSE
Open or short circuit in shift solenoid C signal system (when the TCM monitors
•
solenoid output voltage, voltage that differs from the ON/OFF signal output by
CPU in TCM is detected).
Diagnostic support note:
This is continuous monitor (CCM).
•
MIL illuminates if TCM detects the above malfunction condition during the first
•
drive cycle.
PENDING CODE is not available.
•
FREEZE FRAME DATA is available.
•
AT warning light illuminates.
•
DTC is stored in TCM memory.
•
Shift solenoid valve C malfunction
•
Open circuit in wiring harness between shift solenoid valve C terminal A and
•
TCM terminal 2V
Short to ground in wiring harness between shift solenoid valve C terminal A and
•
TCM terminal 2V
Short to power supply in wiring harness between shift solenoid valve C terminal
•
A and TCM terminal 2V
Damaged connector between shift solenoid valve C and TCM
•
TCM malfunction
•
(w)
RX-8 Transmission (Manual & Auto)
Page 230