Headliner Removal/Installation - Mazda RX-8 Manual

Hide thumbs Also See for RX-8:

Table of Contents

HEAD IMPACT PAD

HEAD IMPACT PAD REMOVAL/INSTALLATION

1. Remove the following parts:

a. Roof side trim(See ROOF SIDE TRIM REMOVAL/INSTALLATION .)

b. A-pillar trim(See A-PILLAR TRIM REMOVAL/INSTALLATION .)

c. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)

d. Inner scuff plate(See INNER SCUFF PLATE REMOVAL/INSTALLATION .)

e. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)

f. Rear pillar trim(See REAR PILLAR TRIM REMOVAL/INSTALLATION .)

g. Map light(See MAP LIGHT REMOVAL/INSTALLATION .)

h. Interior light(See INTERIOR LIGHT REMOVAL/INSTALLATION .)

i. Sunvisor(See SUNVISOR REMOVAL/INSTALLATION .)

j. Assist handle(See ASSIST HANDLE REMOVAL/INSTALLATION .)

k. Headliner(See HEADLINER REMOVAL/INSTALLATION .)

2. Remove the fastener.(Rear)

3. Pull the head impact pad outward and detach clips A and B.(Front)

4. Pull the head impact pad outward and detach clips B.(Rear)

5. Remove the head impact pad.

6. Install in the reverse order of removal.

HEADLINER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Partially peel back the seaming welt.

3. Remove the following parts:

a. Roof side trim (See ROOF SIDE TRIM REMOVAL/INSTALLATION .)