DTC P0753
DTC P0753
Shift solenoid A circuit malfunction (open circuit/short to ground or power supply)
DETECTION
CONDITION
POSSIBLE
CAUSE
Open or short circuit in shift solenoid A signal system (when the TCM monitors
•
solenoid output voltage, voltage that differs from the ON/OFF signal output by
CPU in TCM is detected)
Diagnostic support note:
This is a continuous monitor (CCM).
•
MIL illuminates if TCM detects the above malfunction condition during the first
•
drive cycle.
PENDING CODE is not available.
•
FREEZE FRAME DATA is available.
•
AT warning light illuminates.
•
DTC is stored in TCM memory.
•
Shift solenoid A malfunction
•
Open circuit in wiring harness between shift solenoid A terminal A and TCM
•
terminal 2Y
Short to ground in wiring harness between shift solenoid A terminal A and TCM
•
terminal 2Y
Short to power supply in wiring harness between shift solenoid A terminal A and
•
TCM terminal 2Y
Damaged connector between shift solenoid A and TCM
•
TCM malfunction
•
(w)
RX-8 Transmission (Manual & Auto)
Page 203