IGNITION SWITCH
IGNITION SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the column cover.(See COLUMN COVER REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
1 Connector
2 Screw
3 Ignition switch
4. Install in the reverse order of removal.
IGNITION SWITCH INSPECTION
1. Verify that the continuity between the ignition switch terminals is as indicated in the table.
If not as indicated in the table, replace the ignition switch.
•
(w)
RX-8 Body
Page 385