DTC P0846
DTC P0846
DETECTION
CONDITION
POSSIBLE CAUSE
Oil pressure switch C circuit malfunction
When driving, hydraulic pressure should be generated in the high clutch, but
•
oil pressure switch C does not turn on.
When driving, hydraulic pressure should not be generated in the high clutch,
•
but oil pressure switch C does not turn off.
Diagnostic support note:
This is continuous monitor (CCM).
•
AT warning light illuminates if TCM detects the above malfunction
•
conditions in two consecutive drive cycles.
PENDING CODE is available.
•
FREEZE FRAME DATA is available.
•
MIL does not illuminate.
•
DTC is stored in TCM memory.
•
Oil pressure switch C malfunction
•
Open circuit in wiring harness between oil pressure switch C terminal A and
•
TCM terminal 2F
Short to ground in wiring harness between oil pressure switch C terminal A
•
and TCM terminal 2F
Damaged connector between oil pressure switch C and TCM
•
TCM malfunction
•
(w)
RX-8 Transmission (Manual & Auto)
Page 240