Appendix A Transducer Blocks And Views - Emerson Micro Motion 2700 Configuration And Use Manual

Appendix A
Transducer blocks and views
Topics covered in this appendix:
•
•
•
•
•
•
•
•
•
List of transducer blocks
The fieldbus interface is implemented via the following transducer blocks.
Table A-1:
Transducer block
Measurement
Calibration
Diagnostics
Device information
Local display
Petroleum measurement
Concentration measurement
Density Viscosity meter
Configuration and Use Manual
Descriptions of transducer block table entries
Measurement transducer blocks
Calibration transducer blocks
Diagnostics transducer blocks
Device information transducer blocks
Local display transducer blocks
Petroleum measurement transducer blocks
Concentration measurement transducer blocks
Density viscosity meter transducer blocks
Transducer blocks
Description
Configuration parameters and data for mass flow rate, volume
flow rate, density, and temperature
Calibration parameters and data for mass flow, auto zero, densi-
ty, T-Series coefficients, temperature, pressure compensation,
and temperature compensation
Diagnostic parameters for slug flow setup, alarm status, general
diagnostics, and meter fingerprinting
Contains informational static data such as software revisions, se-
rial numbers, and sensor data
Contains local display (LDO) configuration data
Contains PM process variables and configuration data
Contains concentration measurement process variables and con-
figuration data
Contains parameters and data for the Density Viscosity meters
Transducer blocks and views
127