Configure The Process Variables And Diagnostic Variables Shown On The Display - Emerson Micro Motion 2700 Configuration And Use Manual

Configure device options and preferences
5.1.2 Configure the process variables and diagnostic variables
shown on the display
Display
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Variables
Fieldbus host
Overview
You can control the process variables and diagnostic variables shown on the display, and
the order in which they appear. The display can scroll through up to 15 variables in any
order you choose. In addition, you can repeat variables or leave slots unassigned.
Restriction
Display Variable 1 must be set to a process variable.
Note
If you configure a display variable as a volume process variable and then change Volume Flow Type,
the display variable is automatically changed to the equivalent process variable. For example, Volume
Flow Rate would be changed to Gas Standard Volume Flow Rate.
Procedure
For each display variable you want to change, assign the process variable you want to use.
Example: Default display variable configuration
Display variable
Display Variable 1
Display Variable 2
Display Variable 3
Display Variable 4
Display Variable 5
Display Variable 6
Display Variable 7
Display Variable 8
Display Variable 9
Display Variable 10
Display Variable 11
56
Not available
Device Tools > Configuration > Transmitter Display > Display Variables
LDO TB > LDO_VAR_1_CODE (OD Index 25) to
LDO TB > LDO_VAR_15_CODE (OD Index 39)
Process variable assignment
Mass flow
Mass total
Volume flow
Volume total
Density
Temperature
Drive gain
None
None
None
None
Micro Motion Model 2700 Transmitters with FOUNDATION Fieldbus