Configure Informational Parameters - Emerson Micro Motion 2700 Configuration And Use Manual

Table 5-1: Status alerts and Status Alert Severity
Alert code Status message
Meter Verification Aborted Fault
A035
A102 Drive Overrange
A104 Calibration in Progress
A105 Slug Flow
A107 Power Reset Occurred
A116 Temperature Overrange
(Petroleum)
A117 Density Overrange (Petro-
leum)
A120 Curve Fit Failure (Concen-
tration)
A121 Extrapolation Alarm (Con-
centration)
A128 Factory Configuration Data
Invalid
A129 Factory Config ChkSum Er-
ror
A131 Meter Verification in Pro-
gress: Outputs to Last
Measured Value
5.6

Configure informational parameters

The informational parameters can be used to identify or describe your meter. They are not
used in process measurement and they are not required.
Configuration and Use Manual
(continued)
Default severity Notes
Applies only to transmitters with
Smart Meter Verification.
Informational
Informational Can be set to either Informational or
Ignore, but cannot be set to Fault.
Informational
Informational
Normal transmitter behavior; oc-
curs after every power cycle.
Informational Applies only to transmitters with
the petroleum measurement appli-
cation.
Informational
Applies only to transmitters with
the petroleum measurement appli-
cation.
Informational
Applies only to transmitters with
the concentration measurement
application.
Informational
Applies only to transmitters with
the concentration measurement
application.
Fault
Fault
Informational Applies only to transmitters with
Smart Meter Verification.
Configure device options and preferences
Configurable?
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
No
No
Yes
67