View And Acknowledge Status Alerts; View And Acknowledge Alerts Using The Display - Emerson Micro Motion 2700 Configuration And Use Manual

Table 7-1: Transmitter status reported by status LED
LED state Description
Flashing red (if ena- One or more high-severity alerts are active
bled) and have not been acknowledged.
7.4

View and acknowledge status alerts

The transmitter posts status alerts whenever a process variable exceeds its defined limits
or the transmitter detects a fault condition. You can view active alerts, and you can
acknowledge alerts. Acknowledging alerts is not required.
•
•
•
•
7.4.1

View and acknowledge alerts using the display

You can view a list containing all alerts that are active, or inactive but unacknowledged.
From this list, you can acknowledge individual alerts.
Note
Only Fault and Informational alerts are listed. The transmitter automatically filters out alerts with
Status Alert Severity set to Ignore.
Prerequisites
Operator access to the alert menu must be enabled (default setting). If operator access to
the alert menu is disabled, you must use another method to view or acknowledge status
alerts.
Procedure
See Figure
Configuration and Use Manual
View and acknowledge alerts using the display
View and acknowledge alerts using ProLink III
View alerts using the Field Communicator
View alerts using a fieldbus host
7‐2.
(continued)
Recommendation
A high-severity alert condition affects meas-
urement accuracy and output behavior. Re-
solve the alert condition before continuing.
Acknowledge the alert if you choose.
(Section 7.4.1)
(Section 7.4.2)
(Section 7.4.3)
(Section 7.4.4)
Transmitter operation
79