Initial Setting - Mitsubishi MELSEC Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-AD)

5.4 Initial Setting

5 - 14
[Purpose]
The following A/D initial setting parameters are set:
• A/D conversion enable/disable setting
• Averaging process specification
• Average time/Average number of times/Move average/Time constant settings
• A/D conversion starting time setting (Q62AD-DGH)
• Warning output settings (Process alarm setting)
• Process alarm upper upper limit value/upper lower limit value/lower upper limit
value/lower lower limit value
• Warning output settings (Rate alarm setting)
• Rate alarm upper limit value/lower limit value
• Rate alarm warning detection period
• Input signal error detection extended/input signal error detection setting
• Input signal error detection setting value/input signal error detection lower limit
setting value
• Input signal error detection upper limit setting value
Configuring the parameters on the initial setting window eliminates the need for
parameter settings using a sequence program.
[Operating procedure]
1
"Start I/O No. "
CH Initial setting
1: Enter the start I/O No. in hexadecimal.
[Setting screen]
"Module type" "Module model name"
MELSEC-Q
Initial setting
5 - 14