5 UTILITY PACKAGE (GX Configurator-DA)
5.4 Initial Setting
5 - 12
[Purpose of setting]
Set D/A conversion enable/disable with an initial setting parameter. The initial
setting parameter eliminates the need to set D/A conversion enable/disable in the
sequence program.
[Startup procedure]
"Start I/O No. "
[Setting screen]
[Explanation of items]
(1) Setting contents
Set whether D/A conversion is "Enable" or "Disable" for each channel.
(2) Explanation of command buttons
Make text file
End setup
Cancel
POINT
Initial settings are stored in the intelligent function module parameters. After the
initial settings are written to the CPU module, they are validated by operating the
RUN-STOP switch as follows, STOP
OFF and then ON, or resetting the CPU module.
When using a sequencer program to write the initial settings, when the CPU is
switched from STOP to RUN the initial settings will be written, So ensures that
programming is carried out to re-execute the initial settings.
"Package name"
"Module model name"
Outputs the screen display in text file format.
Confirms the setting data and ends the operation.
Cancels the setting data and ends the operation.
RUN
MELSEC-Q
Initial setting
STOP
RUN, turning the power
5 - 12