Offset/Gain Setting Operation - Mitsubishi MELSEC Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-AD)

5.6.2 Offset/gain setting operation

5 - 21
Perform the offset/gain setting operation in the following sequence.
(1) Switch to the offset/gain setting screen
Perform the operation in Section 5.6.1 to display the offset/gain setting screen.
At this point, a dialog box to confirm the transition of module's operation mode
(normal mode -> offset/gain setting mode) is displayed. Click the Yes button to
transit to the offset/gain setting mode.
(2) Specify channels
Place check marks in "Channel selection" column to specify the channels for
each of which the offset or gain setting is to be made.
(3) Apply current/voltage
Apply current or voltage to the module. Note that "Current" only is allowed for the
Q62AD-DGH.
(4) Execute offset/gain setting
For each of the channels specified in (2), click the Offset setting or
Gain setting button to execute respective setting.
(5) Write settings into module
Write the content set up by operations (2) to (4) into module by clicking the
Registration button.
(a) Precautions
Avoid the following operations while the contents specified in the operations
(2) to (4) is written to the module.
Doing so may cause an error in the data inside the E
A/D converter module failing to operate normally.
1) Powering OFF the programmable controller CPU
2) Resetting the programmable controller CPU
MELSEC-Q
2
PROM, resulting in the
5 - 21