Ch Digital Output Value (16Bit) (Buffer Memory Addresses 11 To 14: Un\G11 To Un\G14); Write Data Error Codes (Buffer Memory Address 19: Un\G19) - Mitsubishi MELSEC Q Series User Manual

3 SPECIFICATIONS
3.4.7 CH digital output value (16bit) (buffer memory addresses 11 to 14: Un\G11 to
Un\G14)

3.4.8 Write data error codes (buffer memory address 19: Un\G19)

3 - 56
(1) The value in the digital output value (32bit) (buffer memory addresses 54 to 61:
Un\G54 to Un\G61) is converted and the result of conversion is stored in 16-bit
signed binary.
(2) When setting the analog input range from 1 to 5V (Extended mode) or 4 to 20
mA (Extended mode), select the digital output value (32bit) (buffer memory
addresses 54 to 61: Un\G54 to Un\G61).
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
Signed bit
1: Negative
0: Positive
(3) While Operating condition setting request (Y9) is ON, 0 is stored into this area.
(4) For the read-out of digital output values, configure A/D conversion completed
flag (XE) or A/D conversion completed flag (buffer memory address 10: Un\G10)
to act as an interlock.
(1) The error codes generated by the A/D converter modules are stored here.
(2) See Section 8.1 for the details of the error codes.
Data section
MELSEC-Q
3 - 56