Adjustment And Initial Setting; Flowchart Of Test Run And Adjustment; Password Setting - Mitsubishi LE-30CTN Instruction Manual

4. Adjustment and Initial Setting

4. Adjustment and Initial Setting
4.1

Flowchart of test run and adjustment

• Before starting automatic operation, check and adjust the controller as follows.
(1)
Installation and wiring
of controller.
4.2

Password setting

• In the adjustment mode, a password can be set for sifting to an adjustment/setting item selection screen.
• When a password is set, the password input screen is displayed when the power is turned ON in the
adjustment mode (DIP.SW8 is turned OFF). The screen cannot be moved to the adjustment/setting item
selection screen without inputting the password set in this screen.
4.2.1 Password setting
• In an adjustment mode (power ON with DIP. SW8 OFF), select item No.54 to set.
• When a password setting is not necessary, alteration from the default (=0) is not required.
Adjustment/setting
item selection screen
• As to the password, "4095" is predetermined. Thus, the value set through above-mentioned operation and
"4095" are effective as the password.
(2)
Controller
• Setting DIP switches
• Adjustment of
Refer to pages 11 and 22.
(4)
Operation check while
performing automatic
operation.
- - - - - - - Item number : 54
On the adjustment/setting item selection screen, set the item number to
[54], and then press the
Set the value on a password setting screen.
• Setting range - - - - -0 to 30000 - - - - Initial value=0
tension detector
(5)
Adjustment of
operation parameters,
if necessary
(6)
Inspection after
occurrence of error
Refer to pages 46, 47
and 48.
key.
4.1 Flowchart of test run and adjustment
(3)
Drive system check
while performing
manual operation.
(7)
Completion of
adjustment
21