Mitsubishi MELSEC Q Series User Manual page 211

7 ONLINE MODULE CHANGE
7 - 34
(f) Set the channel for use to conversion enable in A/D conversion
enable/disable setting (buffer memory address 0: Un\G0), and then turn on
and off Operating condition setting request (Y9). Monitor the digital output
values (buffer memory addresses 11 to 14, 54 to 62, Un\G11 to Un\G14,
Un\G54 to Un\G62) to check whether proper conversion has been made or
not.
(g) Since the new module is in a default status, it must be initialized by a
sequence program after control resumption.
Before performing initialization, check whether the contents of the
initialization program are correct or not.
1) Normal system configuration
The sequence program should perform initialization on the leading
edge of Module READY (X9) of the A/D converter module.
When control resumption is executed, Module READY (X0) turns ON
and initialization is performed. (If the sequence program performs
initialization only one scan after RUN, initialization is not performed.)
2) When used on remote I/O network
Insert a user device that will execute initialization at any timing
(initialization request signal) into the sequence program. After control
resumption, turn ON the initialization request signal to perform
initialization. (If the sequence program performs initialization only one
scan after a data link start of the remote I/O network, initialization is not
performed.)
(5) Resumption of control
(a) After choosing [Diagnosis] - [Online module change] on GX Developer to
redisplay the "Online module change" screen, click the [Execution] button to
resume control. Module READY (X0) turns on.
(b) The "Online module change completed" screen appears.
MELSEC-Q
7 - 34