Led Indicators - Lennox iComfort S30 Installation And Setup Manual

Seal wire hole in wall to prevent
cold or hot air from affecting temperature
sensor in display.
IMPORTANT
Seal wire hole in wall to prevent cold or hot air from affecting temperature
sensor in HD Display.
5. Strip 1/4" (7 mm) insulation from end of each wire.
1/4"
6. Use a level to align either the mag-mount or wall plate on wall horizontally.
7. Remove cover from mag-mount by inserting a flat-head screwdriver into
the slot on each side of the mag-mount. Give it a gentle twist to separate
the two sections.
Slot
8. Use Mag-Mount as a template to mark the desired mounting hole locations
on the wall.
9. Drill 3/16" (5 mm) holes at marked locations on the wall for anchors. Then
insert wall anchors into holes until flush with the wall.
Drill Holes
DO NOT over-tighten mounting screws. Doing so my distort the mag-mount
plastic housing and cause connection issues when installed the HD display.
10. Secure mag-mount to wall or through wall-plate to wall with provided #6 x
1.25" pan-head screws (4).
11. Connect thermostat wiring to Mag-Mount terminals referencing provided
wiring diagrams in this guide.
12. Reinstall access cover.
NOTE: Verify that the Mag-Mount access cover is reinstalled correctly to the
Mag-Mount base. The access cover must be flush with the base or
could cause power or communication issues.
lED I
nDICators
1. A blue LED is visible on the front of the Mag-Mount when it is connected,
Slot
power applied, and the HD Display has not been installed (see following
illustration). The blue LED is also visible through the top vent of the Mag-
Mount near the top-left corner when the HD Display is installed.
6
Use either the Mag-Mount or wall
plate as a template to mark the
desired mounting hole locations
on the wall.
Insert in hole until flush with wall.
WARNING