Shipping And Packing List; Operating And Storage Environment, Electrical And Dimensions; Smart Hub External Components, Button, Leds, Jumpers, Terminals And Wiring Specifications; External Component Locations - Lennox iComfort E30 Installation And Setup Manual

Shipping and Packing List

Quantity Description
1 iComfort® E30 smart thermostat which includes a Smart Hub and HD Display
6 Mounting screws (#6 X 1.25" pan head) - Display requires 4 and smart hub 2.
6 Wall anchors (alligator flanged solid wall anchors)
1 Installation and setup guide
1 User guide
1 Checklist
1 Warranty certificate
IMPORTANT
The iComfort E30 smart thermostat CAN NOT be connected as a
communicating device to indoor or outdoor units. Only conventional 24VAC
wiring to indoor and outdoor units is supported.
NOTE: Due to Lennox' ongoing commitment to quality, features and options
are subject to change without notice and without incurring liability.

Operating and Storage Environment, Electrical and Dimensions

• Operating Temperature is 32°F to 104°F (0 to 40°C)
• Shipping and storage temperature range is -4°F to 140°F (-20°C to 60°C)
• Operating humidity range is 10% to 90% non-condensing at 104°F (40°C)
• Storage humidity range is 5% to 95% non-condensing at 104°F (40°C)
• Smart Hub Power Input: 24VAC, 1AMP at 60Hz.
• Smart Hub Power Output to HD Display: 12VDC
• Dimensions (H x W x D):
HD Display with subbase attached: 7-1/4" x 5" x 1" (184 x 122.5 x 23
»
mm)
Smart Hub: 11-1/2" x 7-1/8" x 1-7/8" (292 mm x 181 mm x 48 mm) -
»
antenna length is 7-1/4" (184 mm)
Smart Hub External Components, Button, LEDs, Jumpers,
Terminals and Wiring Specifications

External Component Locations

E30 Smart Hub
Unit Type and
(Hinged Cover Removed)
Heat Stages Jumpers
0 1 2 3
Communication
UNIT HEAT
TYPE STAGES
Status LED
Outdoor and Discharge
Air Sensors
Smart Hub mount
screw location
W1 W2 W3 G Y2 Y1 C DS R H O B
24VAC Control Wiring Connections
to Indoor Unit
NOTE THE TERMINAL ARRANGMENT ON THE NOTE THE TERMINAL ARRANGMENT ON THE
Figure 1. Smart Hub External Components

Push Button Function

The smart hub push button switch has two primarily functions.
• Rebooting: Press and hold the button for five seconds to reboot the smart
hub.
• Commissioning: Quickly press and release the button to start the process
of creating a direct network connection between the smart hub and mobile
device running the iComfort Mobile Setup application.
The push button has a LED associated with it that indicates the status of the
smart hub commissioning state (see "Table 1. System and Commissioning
LED Indicators" on page 4).

LED Indicators

When alarms are present, you may review alarm(s) listed either on the
homeowner notification screen or the menu / settings > advanced settings >
dealer control center > notifications screen.
3
Antenna
System Status LED
Mobile Device
Commissioning Status LED
Hinged Cover
COMMBUS
-
ACC1 ACC2 + A B (Removable)
Power
and Data Connections
SMART HUB 3.0 SMART HUB 3.0
USB Port
Reboot and Commissioning
Button