External Components; Push Button Functions - Lennox iComfort S30 Installation And Setup Manual

• Do not install the Smart Hub on or near large metal objects. This could
adversely affect the range and directional coverage of the Smart Hub
Wi-Fi signal.
• If the Smart Hub MUST be installed on a metal object, orientate the
antenna perpendicular to the metal surface.
• In all cases, the Smart Hub antenna orientation may need to be
adjusted to obtain best Wi-Fi results.
2. Use the following procedure outlined in "Figure 1. Smart Hub Installation"
to install the Smart Hub controller.
USE SMART HUB AS TEMPLATE TO MARK DESIRED MOUNTING
LOCATIONS ON WALL OR STUD.
A
CAUTION: DO NOT OVERTIGHTEN LOWER MOUNTING SCREW, MAY
DAMAGE SMART HUB.
THROUGH-HOLE
F R O N T
STRIP 1/4" INSULATION FROM
B
END OF EACH CONTROL WIRE
1/4"
C MAKE CONNECTIONS TO SMART HUB
USING WIRING DIAGRAMS PROVIDED
18-GAUGE THERMOSTAT WIRE
Figure 1. Smart Hub Installation
KEYHOLE
R E A R
SECURE SMART-HUB TO
D
WALL WITH
FIELD-PROVIDED
FASTENERS
SMART HUB WIRE
CONNECTORS
PUSH SPRING-LOADED LEVER IN AND
INSERT WIRE THROUGH
HOLE LOCATED ON
BOTTOM SIDE OF
CONNECTOR. RELEASE
LEVER TO SECURE WIRE.
3. For low voltage wiring connections use diagrams in section titled
"Connecting Low Voltage Wiring" on page 8.
E C
xtErnal omponEnts
Terminal Connection Access Cover
Figure 2. Smart Hub Indicators and External Components
p B F
ush utton unCtIons
The Smart Hub push button switch has two primarily functions.
• Rebooting: Press and hold the button for five seconds to reboot the Smart
Hub.
• Commissioning: Quickly press and release the button to start the process
of creating a direct network connection between the Smart Hub and mobile
device running the iComfort Mobile Setup application.
4
System Status LED
System Commissioning
Status LED
Antenna
USB Port
Dealer commissioning and
manual reboot button