Dehumidification Settings; Dehumidification Setting Options; Overcooling; Dehumidification Set Point - Lennox iComfort S30 Installation And Setup Manual

On this screen general information needs to be verified or changed. Touch any
line item to change its contents. Information to be added is address 1, address
2, state, city and zip/postal code.
Complete the requested information and press the continue button.

Dehumidification Settings

For firmware version 3.15 and later, all controls for dehumidification are listed
at menu > settings > humidity. Under Humidity Control, select dehumidify
to enable dehumidification. By default it is disabled.
When dehumidify is enabled, the options are as follows and are dependent on
equipment type and accessory installed.
D s o
EhumIDIFICatIon EttIng ptIons
• Normal — Recommend when the air outside is not too humid.
• Max —
» Single and Two-Stage Outdoor Units or Modulating outdoor units
without a Discharge Air Temperature Sensor (DATS) Installed.
Recommend when outdoor air is excessively humid. May cool
your home below the set temperature.
NOTE: Recommend use of discharge air temperature sensor (DATS) catalog
number 88K38 when modulating outdoor units are used.
» Modulating Outdoor Units with DATS installed. Recommended
when outdoor air is excessively humid. Adjusts cooling based on
duct sensor data. May cool your home below the set temperature.
• Climate IQ (Auto) — Automatically adjusts fan speeds and cooling power
based on local climate conditions, using Climate IQ technology. May cool
your home below the set temperature.
o
vErCoolIng
Slide bar adjust with a range of 0°F to 4°F (-17.8 to -15.5°C). Only available
when Max or Climate IQ is selected.
D s p
EhumIDIFICatIon Et oInt
Slide bar adjust with a range of 40% to 60%.
a D D
DvanCED EhumIDIFICatIon EsCrIptIons
See table 1 for detail information concerning system operations when using
Normal, Max or Climate IQ settings.
Home Address
39