Hd Display Components And Installation; Installation - Lennox iComfort S30 Installation And Setup Manual

Smart Hub
Table 3. Communication Error Troubleshooting
(Mag-Mount to Smart Hub)
Possible Connection Issues
One communication wire at either the Mag-
Mount or Smart Hub COMM BUS A or B termi-
nals is disconnected.
Both communication wires – at either the Mag-
Mount or Smart Hub COMM BUS A or B are
disconnected.
Both communication wires – at either the
Mag-Mount or Smart Hub COMM BUS A or B
terminals are reversed.
Power wires at either the Smart Hub or Mag-
Mount 12VDC + and - terminals are disconnect-
ed.
If terminals are connected correctly, then check
HD Display mounting to Mag-Mount. HD Display
may not be secured correctly to Mag-Mount.
System Status LED
System Commissioning
Status LED
Mag-Mount
Blue LED Location
COMM BUS
12VDC
+ - A B
Mag-Mount
S30 Smart
LED Condition
Hub - System
(HD Display
Status LED
Removed)
Flashing Magenta
Steady Blue
LED
Flashing Magenta
Flashing Blue
LED
Flashing Magenta
Flashing Blue
LED
Flashing Magenta
Off
LED.
Flashing Magenta
LED.
HD Display screen
LED not visible
may be either blank
when HD Display is
or a message indicat-
installed.
ing iComfort cannot
communicate with the
equipment.

HD Display Components and Installation

I
nstallatIon
1. Hold the HD Display by the edges, line it up with the Mag-Mount (horizontal
position), and move the HD Display toward the Mag-Mount.
2. When the magnets in the Mag-Mount attract the HD Display, guide it toward
the Mag-Mount and let the magnets pull it into place.
3. Lightly press on the sides of the HD Display to verify it is completely seated
on the Mag-Mount.
4. To remove the HD Display from the Mag-Mount, rotate the HD Display right
or left (clockwise or counter-clockwise) at least 30 degrees to disengage
the plastic hooks and then pull it straight off of the Mag-Mount
Failure to rotate the HD Display before pulling it off of the Mag-Mount may
loosen the dry wall anchors or pull the Mag-Mount off of the wall due to the
increased forced required to separate the HD Display from the Mag-Mount
when it is not rotated.
NOTE: If the HD Display is removed from the Mag-Mount base, the HD Display
will shut down and will not be able to communicate with the system.
System can be controlled from mobile devices or consumer/dealer web
portals once registration has been completed.
5. Do not remove the label covering the HD Display screen until after power
is applied to the system.
CAUTION
1) Battery may need to charge before operation. Once the display
is connected, instructions may appear within 15 seconds with
further detail.
2) TO AVOID BREAKING THE GLASS DISPLAY
a. Do not apply force directly to the glass display
b. Holding the display horizontally
i. Center the display cavity on the base
ii. Press both sides equally until the snaps engage
3) AVOID EXCESSIVE FORCE TO THE CLASS DISPLAY
7
WARNING