Reminders; Iharmony Zoning; Commissioning Completion - Lennox iComfort S30 Installation And Setup Manual

r
EmInDErs
This screen allows you to set reminders as either disabled or 3, 6, 12 or 24
months and also custom by specific date. The other options on this screen is to
trigger the reminder event either by calendar or actual system run-time.
1. Reminders may be set for replace filter 1, replace filter 2, replace UV
bulb, replace humidifier pad, PureAir™, PureAir S maintenance and
maintenance reminder. Once a reminder is set for a specific item, touch
done to return to the previous screen. An "expires on date" will appear next
to the item just set.
2. Once completed touch continue.
h Z
I armony onIng
This screen will only appear if the iHarmony
screen allows you to rename each zone. You may use the preset names or
any custom name you may desire. If zoning is not applicable, proceed to the
next section.
1. Touch on any zone to rename it. A screen will display that list several
predefined names that can be used which are master bedroom, guest
bedroom, kitchen, living room, media room, dining room, library or custom.
When a predefine name is selected, a green check-mark will appear next
to the selected name.
2. When creating a custom name, touch custom, enter a name and touch
back to return to the previous screen. A new unique zone name can be
created for all four zones.
3. When completed, touch done to return to the zoning screen and verify the
new name is being used for the specific zone.
4. Once completed touch continue.
SET UP AIRFLOW PER ZONE
This screen will allow the installer to setup the airflow per zone. The types of
circulation per zone are:
• Blower Circulation Airflow (gray) which includes total, assigned, minimum
and maximum airflow.
• Heating Circulation Airflow (red) which includes total, assigned, minimum
and maximum airflow.
• Cooling Circulation Airflow (blue) which includes total, assigned, minimum
and maximum airflow.
zoning system is detected. This
®
1. Touch on the circled green arrow to touch a specific zone. The that zone
settings will expand to allow the installer to adjust CFMs for each circulation
airflow type. Use the plus and minus buttons to adjust CFMs up and down.
2. Once completed touch to continue. The next screen that will appear is the
Dealer Control Center.
C C
ommIssIonIng omplEtIon
Once commissioning is completed, the system will leave you at the Dealer
Control Center. You can either touch exit to go to the main screen or perform
any function listed in the various categories displayed.
19